Notice:Only the official website contact information we posted was authorized, beware of being deceived. If lost, the company shall not be responsible.
News
Using Introduction

¡¡¡¡Putting the electrode in a clean and dry place, avoiding the shaking and crashing, then stoving it before using

¡¡¡¡When connect the joint, clean the hole with compressed air, then screw it in, don¡¯t destroy the screw thread

¡¡¡¡When connect the electrode, clean the surface of the two electrodes with compressed air when they are at a distance of 20-30mm

¡¡¡¡When connect the electrode with spanner, it should tighten to the designated location, the interval of two electrodes should be less than 0.05mm.

¡¡¡¡To avoid broking the electrode, please avoid insulation material block

¡¡¡¡To avoid broking the electrode, please put the big material block at the bottom and the small material block up

Copyright 2010-2012, all rights reserved Handan City Feiyue Carbon Co., Ltd Technical support£ºgreat network